![]() ![]() ![]() The 5v is used as a negative voltage in this case which results in 7v. With those fans and the controller you can run them off or very low when you want it quiet or you can crank them up as loud as you want for when your benching or gaming. Standard Molex wires are 12v yellow, ground 1 black, ground 2 black, 5v red fans typically run off of 12v, but if you use 12v positive and connect the 5v to the negative it acts like this 12v + -5v 7v. I believe on Molex's the red cable goes to the red on the 3-pin (depends on the Molex cable you use though). If they connect to the motherboard they'll mention stuff like Aura Sync, MSI Mystic. Or you can twist the wires/solder them together. Either they'll include a controller, connect to the motherboard or you'll need to buy a controller separately. For the RGB part it all depends on the fans. That's for running the fan itself not RGB. You can also clean up your wiring by cutting off the Molex connector and switch from the fans and soldering on a three-pin connector if you have any, or you can even cut the three-pin off of the adapters that come with the Rheobus and solder those unto your Antec fans).Īnd you can also just buy the Rheobus AND two good fans like these Scythes and be done with the Antec Tri-Cool fans altogether. You can then molex to 4 pin fan cables on Amazon. It comes with at least two adapters that you'll plug into the Molex connectors of your fans and then plug into the Rheobus. It's has been one of the best (some say it's the ONLY) fan controllers on the market and it's a true darling of these forums. the molex conector usually sets the fan to run 100 constantly, the 3 pin. Those fans that came with your Antec 300 actually have three positions: low, medium and high.īest thing to control them: Sunbeam Rheobus. My old case had a fan with just a 3 pin connector which I had plugged into the motherboard and thats how Ive been rolling for a few years now, but I see a lot of people saying that its preferred to use the molex connector and plug it into the power supply.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |